Keyless2Go Replacement for Keyless Entry Car Key Fob Vehicles That Use 3 Button KOBLEAR1XT 15042968 Remote, Self-programming

Self-Programmable Remote Car Key Replacement

An inexpensive replacement for your original remote key fob, the Keyless2Go replacement remote is self-programmable and comes with easy do-it-yourself instructions to help you program your new car key fob at home. Enjoy keyless entry on a wide variety of vehicles from Buick, Chevrolet and GMC. Each fob key has been pre-tested to ensure fitment and that signals are transmitting properly. Every remote key fob comes complete with batteries and access to tech support to help get your new smart key working. To ensure this replacement key fob will work with your vehicle, your existing remote key must have the GM # 15042968 and FCC ID: KOBLEAR1XT.

Compatible with:

Cadillac Escalade 2002

Chevrolet S10 2001 - 2004

Chevrolet Silverado 1500 2001 - 2002

Chevrolet Silverado 1500 Hd 2001 - 2002

Chevrolet Silverado 2500 2001 - 2002

Chevrolet Silverado 2500 Hd 2001 - 2002

Chevrolet Suburban 1500 2001 - 2002

Chevrolet Suburban 2500 2001 - 2002

Chevrolet Tahoe 2001 - 2002

GMC Sierra 1500 2001 - 2002

GMC Sierra 1500 Hd 2001 - 2002

GMC Sierra 2500 2001 - 2002

GMC Sonoma 2002 - 2004

GMC Yukon 2001 - 2002

How to Program your Keyless2Go Key Fob Replacement:

All existing transmitters will need to be reprogrammed during this procedure

1. Close all vehicle doors.

2. Insert key into ignition

3. Hold down the UNLOCK button on the driver side door panel. Continue to hold down until instructed to release in step 9.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the ignition switch to the ON position (do not crank the engine)

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position ( do not crank the engine).

8. Turn the ignition switch to the OFF position.

9. Release the unlock button on the door panel. The vehicle should lock and unlock the doors automatically.

10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the doors lock and unlock to confirm programming. – (You may need to hold LOCK & UNLOCK for up to 30 seconds.)

11. Repeat step 10 for each additional transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position to exit the programming mode.